How many years can the anti-seepage membrane of fish pond be used?

Fish pond anti-seepage geomembrane, also known as anti-seepage special membrane for breeding, referred to as fish pond membrane, is specially designed for farming fish, lobster, shrimp, and lotus root users. It has low cost, long service life, no pollution, easy cleaning and construction. Convenience and other advantages, it can be filled with water immediately after the construction is completed, replacing the breeding ponds made of land or cement in the past.
The fish pond membrane is especially suitable for the situation where the soil cannot hold water. In some areas, the sandy soil is filled with a pool of water, and it will be leaked in a short time. In this case, the cost of using the anti-seepage membrane is lower than that of the traditional anti-seepage foundation. The construction is faster and the later maintenance is more convenient.

How many years can the anti-seepage membrane of fish pond be used? The fish pond membrane is made of new polyethylene as the main raw material, and the service life is greatly extended by adding double anti-ultraviolet (anti-ultraviolet and anti-aging components). 0.4-0.5 mm is a common specification for fish pond membranes. As long as it is used properly, the underground service life can reach more than 20 years, and the exposed parts on the slope can be used for more than 6-10 years. The exposed parts on the slope can also be covered with geotextiles, and the service life will be longer. .

How many years can the anti-seepage membrane of fish pond be used? The following introduces the matters needing attention in the use of fish pond membranes and how to lay them: for the renovation of new fish ponds or old fish ponds, the bottom of the fish pond and the slope must be cleaned up, such as small stones, tree roots, and reed roots, all of which must be cleaned, otherwise it will take a long time , plus the pressure of water will puncture the membrane.

Laying fish pond membranes is actually very simple. As long as the previous work is done well, it will save a lot of trouble when laying it later. After digging a pond, first compact and level the slope and bottom, preferably with an area of more than 2 mu of land.

Then measure the size, after measuring the length and width of the bottom, and the slope length, I can help you calculate the size, or you can calculate how many square membranes you need. The width of the fish pond membrane can be produced from 1 meter to 8 meters, and the length is arbitrary. After the membrane is laid, the overlap is 10-15 cm, and the membrane is welded by a welding machine, and all the membranes are welded into a whole to achieve a better quality. Anti-seepage effect.